PK!8990creality_ender3_will_en_0.2_support_ok_parois_ok[general] version = 4 name = Will en 0.2 SUPPORT ok PAROIS ok definition = fdmprinter [metadata] type = quality_changes quality_type = draft setting_version = 6 [values] adhesion_type = skirt layer_height = 0.2 layer_height_0 = 0.1 material_bed_temperature = 50 support_enable = True support_type = everywhere PK!ͤ4%%>creality_ender3_extruder_0_#2_will_en_0.2_support_ok_parois_ok[general] version = 4 name = Will en 0.2 SUPPORT ok PAROIS ok definition = fdmprinter [metadata] type = quality_changes quality_type = draft position = 0 setting_version = 6 [values] bottom_layers = =999999 if infill_sparse_density == 100 else math.ceil(round(bottom_thickness / resolveOrValue('layer_height'), 4)) cool_fan_full_at_height = =0 if resolveOrValue('adhesion_type') == 'raft' else resolveOrValue('layer_height_0') cool_fan_full_layer = 3 cool_fan_speed_0 = 40 infill_pattern = triangles infill_sparse_density = 20 infill_wipe_dist = 0.1 initial_layer_line_width_factor = 100 material_initial_print_temperature = 200 material_print_temperature = 210 material_print_temperature_layer_0 = 210 retract_at_layer_change = True retraction_amount = 6.5 retraction_extra_prime_amount = 0.1 retraction_min_travel = 0.4 retraction_speed = 65.0 skirt_brim_line_width = 0.2 skirt_line_count = 2 speed_print = 60 support_angle = 60 support_brim_width = 4 support_infill_rate = 14 support_interface_density = 90 support_interface_enable = True support_interface_height = 0.8 support_interface_pattern = zigzag support_interface_skip_height = 0.12 support_pattern = zigzag support_xy_distance = 0.5 support_z_distance = 0.25 top_bottom_pattern = zigzag top_bottom_thickness = 0.8 top_layers = =0 if infill_sparse_density == 100 else math.ceil(round(top_thickness / resolveOrValue('layer_height'), 4)) wall_line_count = =1 if magic_spiralize else max(1, round((wall_thickness - wall_line_width_0) / wall_line_width_x) + 1) if wall_thickness != 0 else 0 wall_thickness = 0.8 PK!8990creality_ender3_will_en_0.2_support_ok_parois_okPK!ͤ4%%>creality_ender3_extruder_0_#2_will_en_0.2_support_ok_parois_okPK